KwaZulu-Natal

Cartridges have a spherical outer surface that fits into a conforming surface in the mounting unit (such as pillow block or flange) in the manner of a ball and socket joint. Any shaft misalignment that may exist tends to move the cartridge, seal and bearing together, maintaining the seal on an axis parallel to the shaft.

Cartridges have a spherical outer surface that fits into a conforming surface in the mounting unit (such as pillow block or flange) in the manner of a ball and socket joint. Any shaft misalignment that may exist tends to move the cartridge, seal and bearing together, maintaining the seal on an axis parallel to the shaft.

Cartridges have a spherical outer surface that fits into a conforming surface in the mounting unit (such as pillow block or flange) in the manner of a ball and socket joint. Any shaft misalignment that may exist tends to move the cartridge, seal and bearing together, maintaining the seal on an axis parallel to the shaft.

Cartridges have a spherical outer surface that fits into a conforming surface in the mounting unit (such as pillow block or flange) in the manner of a ball and socket joint. Any shaft misalignment that may exist tends to move the cartridge, seal and bearing together, maintaining the seal on an axis parallel to the shaft.

U-lok seals are made of polyurethane, a wear-resistant material with good elastic properties. U-lok seals will have one rubber lip in contact with the spindle. Because they are in two parts they are easy to install. They are intended for grease lubrication and can accommodate peripheral speeds of up to 8 ms. The permissible angular misalignment for shaft diameters ≤100 mm is approximately 1° and approximately 0,5° for larger sizes.

Double-lip seals are made of polyurethane, a wear-resistant material with good elastic properties. Double lip seals will have two rubber lips that are in contact with the spindle. Because they are in two parts they are easy to install. They are intended for grease lubrication and can accommodate peripheral speeds of up to 8 ms. The permissible angular misalignment for shaft diameters ≤100 mm is approximately 1° and approximately 0,5° for larger sizes.